Vectra help needed

  • Thread starter Thread starter kyle.whitworth
  • Start date Start date
K

kyle.whitworth

Basically all i want to do is remove the bulbs on one of my dashboard
lights, which is working only intermittantly. How do i go about getting
behind the speedo display to the bulbs...
 
Its a 1.8 X reg is all the info i have been given, i am doing the job
for a friend

kyle
 
If memory serves correctly, first remove the steering column shroud. this is
held in place by some screws underneath, and 2 facing you that you can only
get at by turning the wheel and removing the blanking pugs.

then the lighting switch needs removing. this should just pull out, but may
be a bit tight. the whole assembly of rotary switch, dimmer, headlight
dipper and fog switches comes out as a lump.

you also need to pull out one of the 2 centre air vents. problem is, I cant
remember which one. bt all this will reveal the securing screws for the
plastic surrounding the panel. remove all these, and the panelling, which is
in 2 pieces.

now you should be able to locate the instrument panel screws. remove these,
ease forewards and unplug wiring from rear. 2 plugs, 1 each side.

remove instrument cluster.

good luck

Mike
 
If you want to email me at [email protected] I have a word
document which I downloaded from the VVOC site which describes the
whole process complete with pictures.

Jack
 
You must log in or register to reply here.

Latest threads

Back
Top