veccy key fob needs constant reprogramming ...

I've a problem with the key fob needing to be constantly reprogrammed
despite a new battery. is there a sensor i can replace cos its a pain
to open the door manually ?

 

well u could get a new keyfob...lots of pennies!
else i'd say it's probably a dry joint on the fob PCB.
find a friendly man who can solder properly to give it the once over.

mike

 

I had the same problem a couple of months ago, I discovered that one of the
two buttons was sticking down slightly under the plastic case of the fob.
This apparently de-programmes the fob! I cleaned it up & its been fine
since.

Steve...

 

Thanks for replying, just took off the fob cover and sussed out that
the small round thing... battery cover ??? needs to be pushed in till
it clicks before i can operate the open/close buttons.It fits snugger
than before so hopefully that'll be the end of that.
Many thanks for the assistance once again.