B
brake
I can't retract the piston to fit the new pads. Any ideas?
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an alternative browser.
You should upgrade or use an alternative browser.
M
mikeFNB
release the pressure or use a piece of wood /srewdriver
slowly apply gentle pressure keep doing it and they should go in.
becarful not to scratch the disc when doing it, hence use a bit of wood and
a long wide driver, just twist the blade against the wood bewteen the driver
and the disc
till you can use the wood on it's own.
mike
slowly apply gentle pressure keep doing it and they should go in.
becarful not to scratch the disc when doing it, hence use a bit of wood and
a long wide driver, just twist the blade against the wood bewteen the driver
and the disc
till you can use the wood on it's own.
mike
M
me140
Rear calliper pistons screw in - if you push them back the calliper will be
damaged. You need a special tool to wind them back in.
damaged. You need a special tool to wind them back in.
M
mikeFNB
tilt sri
mike
mike
me140 said:Rear calliper pistons screw in - if you push them back the calliper will
be damaged. You need a special tool to wind them back in.
B
brydon.j
Thanks very much. It worked!