astra car radio question

Duncan Newell

Usenet Archive
Joined
May 19, 2003
Messages
10
Reaction score
0
Hi all

I have a Vauxhall Astra ( Y reg ) estate, it has a Philips CAR400 tape/radio in it. Which i have code etc for anyway.

( see for pic
http://www.ascebalo.com/oglasnik/slike/Rubrike/Radio_kazetofoni/Philips/car400.jpg )

I want to take this out and fit a new one i been given that is radio /cd. I work in electronics so am familar with wire up etc, the question is this i have unscrewed the 4 small alan key screws that hold it in tried to pull it out but it wont move at all, is there some thing else im missing does it have another screw ? or do you have to push it from the back or somehow disconnect from back before removing ? I dont want to force it ! ive tried using small presure on sides with a thin screwdriver but it dont seem to want to move, now is it just a matter of using a bit of force as it stuck or is there something i am missing ?

Its a good 10 years since i played around with a car stereo in my old car so any help be greatful.

Duncan
 
Removing the 4 small allen screws gives access to the holes through which you push either the removal tools (which look a bit like flattened horseshoe shaped wire coat hangers) or use a couple of smally screwdrivers on each side at a time to push back a locking plate. If you use the screwdrivers on one side at a time, just push them in and dislodge by pulling that side of the stereo out a bit to get it past the locking plate before doing the other side. If you are careful you won't cause any damage and can pull the stereo unit straight out.

Ben
 
Lamri said:
Removing the 4 small allen screws gives access to the holes through which you push either the removal tools (which look a bit like flattened horseshoe shaped wire coat hangers) or use a couple of smally screwdrivers on each side at a time to push back a locking plate. If you use the screwdrivers on one side at a time, just push them in and dislodge by pulling that side of the stereo out a bit to get it past the locking plate before doing the other side. If you are careful you won't cause any damage and can pull the stereo unit straight out.

Ben
Thanks for that will give that a go tomorrow, i knew i was missing something !
3.30pm just gone and its getting dark outside already ! typical oh well ill try tomorrow day.

Duncan
 
The four screws are just grub screws and do'nt hold it in place. You will have to find a set of stereo pins to remove it.

An alternative is to use small allan keys which you will require 4 off. Push one in each of the holes, and as it goes in you will fell resistance around half way down, this is the stereo releasing itself from the cage. Once all four are done, the stereo will just simply slide out.
 
Yup - you need the removal tolls - a coupe of bits of bent wire , one for each side - you push it into the holes, this pushes back a spring clip then you use the wires as a handle. Buy for a few coppers from Halfords or your VX dealer.

Can make out of bent coat-hangers but this approach can be a pain if you've never seen these things before. Tealeaves do it all the time though.
 
R. Murphy said:
Yup - you need the removal tolls - a coupe of bits of bent wire , one for each side - you push it into the holes, this pushes back a spring clip then you use the wires as a handle. Buy for a few coppers from Halfords or your VX dealer.

Can make out of bent coat-hangers but this approach can be a pain if you've never seen these things before. Tealeaves do it all the time though.
All sorted ok, did it with a old coat hanger worked first time perfect !
thanks

Duncan
 

Latest threads

Back
Top